They assume a rudimentary knowledge of the UniSim Design interface and methods.A-1 The dynamic tutorials (which are continued after the steady state section) are also presented in a step-by-step manner, but are less detailed in their explanations. In steps where more than one method is available to complete a particular action, all methods are outlined. These tutorials explicitly detail each step required to complete the simulation. If you are new to UniSim Design, it is recommended that you begin with the steady state tutorials. If you are interested only in learning to apply dynamic simulation methods, use the pre-built steady state base case, includedĪll completed Tutorial cases are included with your UniSim Design package, and are available on UniSim Design\Samples folder. If you are interested only in steady state simulation, go through the steady state tutorial(s) that most interest you and stop at the dynamics section. The dynamic tutorials use the steady state cases and add control schemes and dynamic specifications required to run the case in Dynamic mode. The three tutorials are grouped in three general areas of interest:Įach area has an associated steady state and dynamic tutorial. After building one of these tutorial cases, you might choose to build one or several more, or begin creating your own simulations. Regardless of which tutorial you work through first, you will gain the same basic understanding of the steps and tools used to build a UniSim Design simulation. The tutorial(s) you choose to work through will likely depend on the simulation topic that is most closely related to your work, your familiarity with UniSim Design, and the types of simulation cases you anticipate on creating in the future. Each tutorial guides you step-by-step through the complete construction of a UniSim Design simulation. The Tutorials section of this guide presents you with independent tutorial sessions. 2-3Ģ.3 Dynamic Simulation.2-102ģ Chemicals Tutorial. 1-88Ģ Refining Tutorial.2-1Ģ.1 Introduction. All rights reserved.Ī UniSim Design Tutorials. Future revisions will incorporate changes, including corrections of typographical errors and technical inaccuracies.
Honeywell may make changes to the requirements described.
The information in this help file is subject to change over time.
0 kommentar(er)
